Pipes

Quick tip #4 – Modeling Pipes and Boolean basics

Josef Blog Roll, CINEMA 4D, Quick Tips, VRay 4 Comments

Modeling pipe joints could be sometimes quite tricky in Cinema 4D , but once you know how use the modeling tools with the handy boolean tool in cinema .. you can then model any kind of joints with only few clicks , as a starter I recommend watching these two videos for some poly/flow basics and other info about the boolean tool .

in this next video i show you an easy way to model a T like pipe

finally here is a video about modeling a 3 way pipe with 60 degrees angle and one pipe as a base

Comments 4

    1. Post
      Author

Leave a Reply to Eduard Caliman Cancel reply

Your email address will not be published. Required fields are marked *